Install Exchange 2016 using unattended mode

Install Exchange 2016 from Command Line

• Make sure you've read the release notes, see Release notes for Exchange 2016.
• Make sure you meet the system requirement. see Exchange 2016 system requirements.
• Install the prerequisites, see Exchange 2016 prerequisites.

NOTE: Renaming a server is not supported after installation of an Exchange 2016.
Permission Requirement: To install Exchange you should either be delegated to run the Setup or should be a member of the Organization Management role group.

Using Setup.exe to install Exchange 2016 in unattended mode

NOTE: If you have User Access Control (UAC) enabled, you must run Setup.exe from an elevated command prompt.

To Install The Exchange Server use the Below CMD.

Setup.exe /mode:Install /role:Mailbox /OrganizationName:LetsExchange /IAcceptExchangeServerLicenseTerms

To install Edge Transport Server use the below CMD.

Setup.exe /mode:Install /r:EdgeTransport /IAcceptExchangeServerLicenseTerms